Change a Propane Tank
Propane powered forklifts are normally utilized inside warehouses. The lift truck is made with the propane tank mounted at the back of the driver. The tanks, that look a lot like beer kegs, have to be replaced from time to time because they have a limited lifespan. Forklift drivers must always use care when handling propane tanks. Compressed gases are very dangerous, particularly because the gas is flammable. Utilize care when removing and replacing propane tank to avoid injury.
1 To change a propane tank, first stop the forklift while leaving the engine running, and turn off the valve on the tank. Let the lift truck run until the engine dies. This process burns the gas off inside the transfer hose which connects the tank and the engine. Prior to taking the second steps, put on the proper safety equipment, such as insulated gloves made of either leather or neoprene. It is vital for you to protect your skin from touching the compressed gas, which is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 Leaks could be inspected simply by applying soapy water to the valve and opening it slightly. If there is a leak, it would cause bubbles to froth from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the valve area, and afterward do the leak checking process again. Persistent leaks mean that the nut and connecting hose should be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank should be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you can start the lift truck and continue working.